Stromberg Carburettor Linkage Kit (STROM9241P)

A premium 2x2 carburetor linkage with rod ends for positive action, die-cast Superlink levers and a stainless steel link rod. Use on intake manifolds with carburetors 4-3/4 inches apart. If in doubt, simply measure your manifold spacing - throttle shaft to throttle shaft. Exclusive to Stromberg Speed Parts, this linkage features 'Snapback' throttle return springs which virtuallydisappear from view. Special bolts were developed with a small blind hole, allowing youto insert eg, a hex key, to tighten the lock nut. And opposite threaded rod ends ensure easy adjustment. Just spin the link rod to correct the lever angles. The linkage comes pre-assembled, installs in just two simple steps and comes with full instructions. Click the other tabs for help with installation and tuning.

OVERVIEW

• Fits Offenhauser 1090 & 1075 2x2 Regular intake
• Fits Edelbrock 1103 2x2 Slingshot intake
• Fits Navarro 2x2 Regular intake
• Fits Eddie Meyer 2x2 High-rise intake
• Fits Thickstun PM-7 High-rise intake
• Works with all Stromberg 9141 TwoStep fuel lines (as pictured)
• Extended throttle shafts not required