Gearbox & Diff / Driveline

Allstar Tapered top drain pan, combined with an open flow corner allow quick change gear changes to happen even faster. Plastic, low profile, 2-pie...

3/4" chromoly cross pin to suit Ford 8" & 9" rear ends. We have cross pins to suit both 2 spider and 4 spider diffs. 2 spider pin (long) 1 requ...

Thread pitch on this pinion nut is 3/4"-20. Fits 8" and 9" Ford rear axles.

We carry a range of axle bearings to suit Ford 8" & Ford 9" rear axle housings. 35mm x 72mm x 21mm - RW207CCR35mm x 80mm x 21mm - DG358028W2RSC...

Ring gear bolts to suit a Ford 8" & 9" Specifications 7/16-20 thread pitch 1-1/4" long Sold individually 10 required for a full set

Spider & pinion gear bevel thrust washer to suit Ford 8" & 9" Sold as a pack of 4

Rear axle differential gasket to suit Ford 8" rear ends.

Stock replacement crush collar/sleeve for Ford 8" rear axles. Collapsible spacer installs on the pinion and preloads the pinion bearings. Crush sle...

Ford 8" Pinion Support Shim Kit Includes 5 assorted shims Fits all Ford 8" pinion supports

This O-Ring is for a 8" Ford Rear end - It does NOT Measure 8" in diameter. 

Pinion pilot bearing to suit a Ford 8"

Ford 8" Inner Pinion Pilot Bearing Retainer Fits all Ford 8" 3rd member cases

Pinion seal to suit a Ford 8"

Specifications Socket Size(s) 3/4 12pt Pro Series 200,000psi UHL 0.750˝ Thread Size 7/16-20

We have a range of Ford 9" crown wheel and pinion sets in store, contact the team at Fast Lane Spares today for availability. Motive Gear Performan...

Rear axle differential gasket to suit Ford 9" rear ends.

Diff plug to suit a Ford 9" 1/2" thread

Heavy duty spring saddle big hole to suit 9" diff housing in Ford, Chev, Holden or custom. Dimensions: 65mm wide 116mm long 34mm centre hole  4mm ...

Heavy duty spring saddle small hole to suit 9" diff housing in Ford, Chev, Holden or custom. Dimensions: 57mm wide 113mm long 15mm centre hole  4m...

U Bolts & nuts to suit a Ford 9" rear end or 3" axle tube. Specifications: 240mm length 82mm inside diameter 130mm thread length  Suit 3" axle...

1310 series pinion yoke to suit a Ford 9" Fits Ford 9" Fits 1310 series u-joint size 28 spline 3.219" snap ring span 1.062" cap diameter Availabl...

Low cost traction. A spool replaces the differential carrier, locking the axle shafts together. Locking the axles provides maximum traction for off...

Ford 9" heavy duty housing with notched back. Comes with studs, nuts and gasket

Clutch set to suit Ford 9" LSD carrier. Includes all steel and fibre plates. Raybestos USA brand as used by Ford.