Gearbox & Diff

Complete 3 speed land cruiser gearboxes! These gearboxes come with: - Backing plate- Driveshaft flange- Shifter Straight out of a landcrusier - th...

Afco Wide 5 Bearing Kit - Includes Inner and Outer Bearings, Seal and Locknut.

Afco Bearing Race - Inner and Outer sold seperately.

Afco Seal to suit back of Wide 5 Hub.

Allstar Aluminum Drain Pan is a must when changing quick change gears. Built-in perforated shelf holds gears and allows lube to drain into pan. Pan...

Allstar Tapered top drain pan, combined with an open flow corner allow quick change gear changes to happen even faster. Plastic, low profile, 2-pie...

Made from Billet Alloy

4 spider LSD carrier to suit Holden & Falcon, Choose from either 25 spline or 28 spline.

Aftermarket TruTrac diff carrier to suit 31 spline axles. Most commonly used to strengthen the Borgwarner diff. Axles available if required, phone ...

IRS needle roller bearing Specifications 38mm inner diamteter 45.23mm outer diameter 12mm width

Borgwarner LSD cone to suit Borgwarner rear ends. Available in 25 or 28 spline

Borgwarner LSD triple spring and thrust plate kit to suit Borgwarner rear ends.

4 spider LSD carrier to suit VTII-VZ Holden Commodore

Mini Spools are designed to replace the spider gears inside the stock, open differential carrier. This unit will NOT work on posi carrier. Use with...

Borgwarner 4 spider cross to suit Borgwarner rear ends.

Borgwarner spider gear set to suit Borgwarner rear ends Kit includes: 4x pinion gears 2x Side gears 1x Spider cross

Caliper Mount to SideBell on K347S Rear End - Suits #120-13405-N Wilwood Midget Dynalite Caliper.

Winters Performance Diff Breather Assembly.

DMI Vault Lock for Superstock / Sprintcar

3/4" chromoly cross pin to suit Ford 8" & 9" rear ends. We have cross pins to suit both 2 spider and 4 spider diffs. 2 spider pin (long) 1 requ...

Thread pitch on this pinion nut is 3/4"-20. Fits 8" and 9" Ford rear axles.

We carry a range of axle bearings to suit Ford 8" & Ford 9" rear axle housings. 35mm x 72mm x 21mm - RW207CCR35mm x 80mm x 21mm - DG358028W2RSC...

Ring gear bolts to suit a Ford 8" & 9" Specifications 7/16-20 thread pitch 1-1/4" long Sold individually 10 required for a full set

Spider & pinion gear bevel thrust washer to suit Ford 8" & 9" Sold as a pack of 4